磁控溅射技术制备ZnO透光薄膜

采用RF磁控溅射方法,在玻璃衬底上制备了择优取向的ZnO薄膜;通过台阶仪、X射线衍射技术、原子力显微镜和分光光度计分别测量了不同溅射功率条件下淀积的ZnO薄膜厚度(淀积速率)、结晶质量、表面形貌与粗糙度、透光光谱,报道了该薄膜结晶质量、薄膜粗糙度与其在可见光区透光率的关系.     

BRD96N光调制吸收增强现象的实验研究

通过光谱响应特性实验和记录／读出图像实验，研究了基因变异型细菌视紫红质（BR_D96N）分子膜对单色光的光调制特性.发现BR_D96N分子膜在550nm—600nm范围内对调制光有吸收增强的现象，且对此范围内不同波长的单色光其调制程度有差异.利用曲线拟和方法发现550nm—600nm吸收增强的变化过程分为快过程和慢过程，其对应的时间常数分别为30s和5min.利用强度调制器的吸收强度与图像灰度之间的关系，分析了560nm—600nm范围内出现图像反转的实验现象. 关键词： 细菌视紫红质D96N分子膜 光谱响应 吸收增强现象 图像反转现象     

PDT光敏剂HA在不同液相体系下的光谱特性研究

为了对候选光敏剂竹红菌甲素(HA)进行改性并保持其优异的敏化特性,对HA的光谱特性和激发态性质作了进一步的指认。系统研究了HA在不同液相体系下的吸收和荧光光谱,对指认HA的光谱和电子跃迁的机制提出了新的依据,结果表明,吸收带I产生于π-π*跃迁,吸收带Ⅱ和Ⅲ产生于P-π共轭所导致的L→aπ跃迁的电子振动结构;荧光发射带I和Ⅱ是产生于同一跃迁机制S1(L,aπ)→S0的正常荧光的振动结构。     

氮化铝薄膜的光学性能

分别使用X衍射仪和紫外（190 nm～800 nm）分光光度仪,测量了用分子束外延法生长在SiC（001）基底面上的AIN薄膜的X衍射、透射谱和不同温度下的吸收谱.X衍射表明:实验所用的AIN薄膜在c-轴存在应变和应力，该应变和应力主要是由于AIN的晶格常量与基底SiC的晶格常量不匹配所致.透射谱表明:AIN薄膜的禁带宽度大约为6.2eV；而其对应的吸收谱在6.2eV处存在一个明显的台阶,此台阶被认为是AIN薄膜中的带边自由激子吸收所产生,忽略激子的结合能(与禁带宽度相比),则该值就对应为AIN的禁带宽度.而其对应的不同温度下（10 k～293 k）的吸收谱的谱线的形状和位置无明显的变化表明:温度对AIN薄膜的禁带宽度亦无明显的影响，这主要是由于在AIN薄膜中存在着应力所致.     

Application of x-ray fluorescence analysis to investigation of the composition of gunshot residues

We have used x-ray fluorescence analysis to study the elemental composition of gunshot residues from smooth-bore and rifled-bore guns. We have established that it is possible to differentiate between types of projectiles (jacketed/lead), types of primers (corrosive/noncorrosive), and types of propellant powders (black/smokeless) by analysis of the elemental composition of the gunshot residues. We have shown that the mercury content in gunshot residues on the surface of the object carrying the residues steadily decreases as storage time increases. Despite this fact, mercury can be preserved as a component of gunshot residues on the object (cotton cloth) under room conditions for more than 45 days. __________ Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 73, No. 3, pp. 320–325, May–June, 2006.     

Refractive index of standard oils as a function of wavelength and temperature

The refractive indices (n) of eight standard oils from Physikalisch Technische Bundesanstalt, Germany were determined with an accuracy of ±1×10⁻⁴ by using Abbe Refractometer. The measurements were performed at temperature 20°C in the spectral range 0.4–0.7 μm. The experimental data were fitted to the simple Cauchy dispersion formula and the results were found to be consistent within the limits of experimental error. In all cases, the refractive index decreased monotonically with increasing wavelength. The refractive indices (n) of these oils have been measured as a function of the temperature t (20°C up to 50°C) at λ=0.589 μm and were found to have linear temperature dependencies. The refractive indices of the studied oils and the uncertainty in their values are calculated at λ=0.589. The Lorentz–Lorenz (L–L) formula has been tested and it was found to be valid with a maximum deviation of 0.4% and was used to calculate the molecular polarizability θ.     

新型噻吩基取代卟啉的合成及其荧光光谱研究

合成了两种新型噻吩基卟啉－5，15－二（2－噻吩基）－2，8，12，18－四乙基－3，7，13，17－四甲基卟啉7a（45．1％）和5，15－二（2－联噻吩基）－2，8，12，18－四乙基－3，7，13，17－四甲基卟啉7b(61.2%),并研究了它们的光谱性质，其中荧光光谱的最大发射峰蜂都在631nm处，量子产率分别为4．1％（7a)和1．4％（7b)。     

Sn-C60薄膜的紫外吸收光谱和X-射线衍射谱分析

对Sn-C60薄膜进行紫外可见光吸收，X-射线衍射和扫描电镜的测定结果显示，薄膜样品紫外可见光吸收的两个短波段吸收峰比纯C60薄膜的吸收峰显著下降，说明Sn-C60薄膜的电子光吸收跃迁为间接跃迁，能带中有杂质能级的存在；样品的X射线衍射峰则对应于面心立方结构；扫描电镜结果显示薄膜为纳米级颗粒组成。     

掺铥氟磷玻璃的结构、热学性质和光谱性质

制备了不同Al(PO3)3含量的掺铥系列氟磷玻璃,研究了其结构、热稳定性和光谱性质。随着Al(PO3)3含量的增加,该系列玻璃的密度降低,折射率增加,差热分析表明,转变温度、析晶起始温度、析晶峰温度和熔化温度增加。Al(PO3)3摩尔浓度在7%~9%时析晶稳定性最佳。采用归一化的拉曼光谱分析了材料的结构和声子状况,对于该系列氟磷玻璃,Al(PO3)3含量的增加不会影响声子能量,但使声子密度增大。测试了样品的吸收光谱,Tm3 的3H6→3F4在第三通信窗口的L波段有明显吸收。与在其它玻璃基质中相比,Tm3 的3F4能级对应能量偏高,3H4能级对应能量偏低,使得3H4→3F4跃迁波长较大,接近于增益迁移光纤放大器的放大波长。扎得奥菲而特(Judd-Ofelt)理论分析表明随着Al(PO3)3含量增加,离子强度参量Ω2增大,Ω6保持相对稳定,Tm3 的能级寿命降低。     

Quadrupole interactions at 57Fe and 119Sn in 3d-metal antimonides

3d-metal antimonides: Fe_1+x Sb, N_+x Sb, Co_+x Sb and the (Ni_1?y Fe _y )Sb solid solution have been studied by the Mössbauer effect method at ⁵⁷Fe and ¹¹⁹Sn. It was found that the quadrupole interactions at the Fe and Sn nucleus in 3d-metal antimonides are very sensitive to the filling of different crystallographic sites with metal atoms. The metal atoms in trigonal-bipyramidal sites have a strong effect on the quadrupole splitting of ¹¹⁹Sn. They are nearest to anions (Sb or Sn) with the typical axial ratio of c/a = 1.25. The QS(x) dependence of ¹¹⁹ Sn in 3d-metal antimonides in the 0 ≤ x ≤ 0.1 concentration range can be used to determine x – the concentration of transition metal excess relative to the stoichiometric composition.